Toshiba TOSVERT VF-s15 VFD using RS485 and USB001Z – Raspberry Pi Forums

Wed May 09, 2018 12:41 pm

I’m currently trying to drive an AC Motor using the TOSHIBA TOSVERT VF-S15 inverter with my Raspberry PI 3 model B. I have a USB-to-serial conversion unit which is the USB001Z. The problem is that the rpi does recognized it but it seems there is no driver for it.
When i plug it and call dmesg i got this :

Code: Select all


[ 1442.099068] usb 1-3: new full-speed USB device number 3 using xhci_hcd
[ 1442.231787] usb 1-3: New USB device found, idVendor=0403, idProduct=e040
[ 1442.231792] usb 1-3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 1442.231794] usb 1-3: Product: USB001Z
[ 1442.231795] usb 1-3: Manufacturer: TSIJ
[ 1442.231797] usb 1-3: SerialNumber: USB001ZX

Code: Select all


Bus 01.Port 1: Dev 1, Class=root_hub, Driver=xhci_hcd/14p, 480M
    |__ Port 1: Dev 2, If 0, Class=Human Interface Device, Driver=usbhid, 12M
    |__ Port 3: Dev 3, If 0, Class=Vendor Specific Class, Driver=, 12M


I’ve done some research and it’s look like Linuxcnc has driver for VFD inverter such as VF-S11
which is close to the VF-S15. So i am wondering if it is possible to compile the HAL for raspbian

If it’s not which USB-to-serial unit should i use to communicate with the TOSVERT VF-S15 ?

Thanks a lot for any help !

Hello everyone,I’m currently trying to drive an AC Motor using the TOSHIBA TOSVERT VF-S15 inverter with my Raspberry PI 3 model B. I have a USB-to-serial conversion unit which is the USB001Z. The problem is that the rpi does recognized it but it seems there is no driver for it.When i plug it and call dmesg i got this :but lsusb -t give me thatSo it seems it’s not natively supported by raspbian. The USB001Z manufacturer (TOSHIBA) provide drivers for windows and no information about linux so i think it’s only windows compatible.I’ve done some research and it’s look like Linuxcnc has driver for VFD inverter such as VF-S11 http://linuxcnc.org/docs/html/drivers/vfs11.html which is close to the VF-S15. So i am wondering if it is possible to compile the HAL for raspbian http://linuxcnc.org/docs/html/man/man1/vfs11_vfd.1.html and if it will work on my raspberry with USB001Z.If it’s not which USB-to-serial unit should i use to communicate with the TOSVERT VF-S15 ?Thanks a lot for any help !