Install an Operating System Using PXE Network Boot - Oracle® Servers X7-2 and X7-2L Operating Systems Installation Guide - The first knowledge sharing application in Vietnam

Ensure that the PXE network environment is properly set up.
Reset or power on the server. See Resetting or Powering on the Server.

The system begins the boot process and the BIOS screen appears.

Note –
The next step occurs very quickly; therefore, be ready to press the F2
key. Watch carefully for messages as they appear on the screen for a
brief time. You might want to enlarge the size of your screen to
eliminate scroll bars.
Verify that PXE boot is enabled. For Oracle Linux and Red Hat Enterprise
Linux, skip to Step 4.

Note –
PXE boot is enabled by default; however, this step directs you to
verify that PXE boot is enabled in the event that it was disabled. After
you verify that PXE boot is enabled, you can omit this step on
subsequent PXE boots.
1. Press the F2 key to access the BIOS Setup Utility.
2. In the BIOS Setup Utility, select Advanced in the top menu
  bar.
3. In the BIOS Setup Utility Advanced screen, select Network
  Stack.
  
  The BIOS Setup Utility Network Stack screen appears.
4. If necessary, set the appropriate PXE Support setting (IPv4 or
  IPv6) to Enabled.
5. To save the changes and exit the BIOS Setup Utility, press the F10
  key.
This causes the server to reset. After resetting, the BIOS screen appears
again.
On the BIOS screen, press the F8 key to specify a temporary boot device or
press the F12 key to network boot (PXE).

The Please Select Boot Device menu appears, listing the available boot
devices.

Note –
The Please Select Boot Device menu options might differ depending on
the type of disk controller and other hardware, such as PCIe network
cards, installed in your server.
On the Please Select Boot Device menu, select the PXE boot port, and press
Enter.

The PXE boot port is the physical network port configured to communicate
with your network install server.

For Oracle Solaris, the GRUB menu appears.
Follow the onscreen prompts to complete the PXE installation.

Note –
From this point on, the installation procedure for Oracle Linux is
site specific as determined by the site Kickstart file.

For instructions on completing the PXE installation, refer to:
- Creating a Custom Oracle Solaris 11.3
  Installation Image at: http://docs.oracle.com/cd/E53394_01/index.html.
- Oracle VM Installation and Upgrade Guide
  for
  Release
  3.4 at: http://www.oracle.com/technetwork/documentation/vm-096300.html.
- Step 6 of Install Windows Server 2012 R2/Windows Server 2016 OS Manually Using Local or Remote Media

Install an Operating System Using PXE Network Boot – Oracle® Servers X7-2 and X7-2L Operating Systems Installation Guide